This is a very sophisticated electronic device which is a combined 100a Watt Meter, Voltage Checker and Lipo Balancer.

A watt meter is an ESSENTIAL item for all electric flyers. How often do you guess your electric set ups? Manufacturers specifications for motors etc are good starting points, but without accurate measurements you can never be sure you are getting the best out of your combination and in many cases you could be damaging your components. Is your ESC of the correct rating? Is there sufficient voltage when under load? Is that prop too big/small? These, and many other questions can be easily answered by using this great device.

A Voltage checker is another essential device, check the state and voltage of each cell of your lipo to see if it is within safe limits.

The integrated balancer has an integrated balanced circuit which is self operative without connecting to a charger. The battery pack will be equalized to the lowest cell voltage of the pack.

As you can see this is a real 'Swis Army Kinife' of a device which contains 3 items in one, and as such represents outstanding value for money!
A 'must have' for all serious electric fliers.

Watt Meter - measures current (Amps), voltage (Volts), power (Watts) and charger (Amp-hours)
Voltage Checker allows you to check the individual cell voltages of a 1 cells to 6 cells
lithium battery. It can handle all types of lithium batteries (LiPo, LiIon, LiFe).Verifies sufficient operating voltage under load
Balancing Function has an integrated balanced circuit which is self operative without
connect to charger. Battery pack will be equalized to the lowest cell voltage of the
pack. Individual cell balancing

Specifications
Voltage: 0-60V , resolution 0.01V (0V minimum with auxiliary power)

Current: 0-100A peak* , resolution 0.1A

Power: 0-6000 W, resolution 0.1W

Cell Count: 1-6 cells
Battery Type: LiPo, LiIon, LiFe

Dimensions: 103x49.5x20mm
Net Weight: 105g
Display: 16 Cha. X 2 row LCD

* 50A continuous, 100A peak, assumes device's wires are in free air and attached to connections at or below temperature of 35°C with adequate air flow. 100A operation time depends on ambient temperature and wiring temperature. In watt-meter mode, you can calibrate all values to zero by pressing 'SELECT' button for more than 3 seconds.

Unit is supplied with 2 x Deans Connectors

To download a PDF of the instruction sheet please click here