The Airtek AirMax Series are our fifth generation Motors following in the footsteps of our hugely popular Excel, Apex and Apex Pro ranges. These motors provide the modeller with the best value outrunners you can buy. Notice the word value, for although these motors may be budget priced the specification is certainly anything but. Featuring 12 Slots and 14 Poles to generate the torque demanded by the serious modeller, CNC Machined from top grade 6061 T6 Alloy and high purity copper windings for maximum efficiency. Add to that ABEC5 Oversize bearings and a stator from super thin (0.2mm) laminations, plus each motor is balanced at the factory for the ultimate in smooth running!
1 x AirMax AM/4250/600 Brushless Outrunner Motor with Pre-Soldered 3.5mm Bullet Connectors
1 x Flat Alloy Cross Mount
4 x Mount Screws
1 x Prop driver assembly and screw set
1 x Instruction Sheet
* These are the MAXIMUM Watts the motor is capable of attaining and not what you will normally get in a real life situation. The cell count and C rating of the battery will both have an effect on the Watts attainable. An average sport lipo can lose around 1 volt per cell under load and this must be factored in when calculating the realistic maximum watts you can attain.
** Recommended ESCs shown are based on you keeping within the operating parameters and specifications. Where space and weight permit consider using an ESC with a higher rating than recommended (i.e. where a 30A is shown fit a 40A) to give plenty of leeway.
This motor is a very approximate equivalent of a .40.46 Glow Motor
Electric motors and i.c. engines are two completely different forms of propulsion and as such direct comparisons are often not the most appropriate way of selecting a motor. However we appreciate that brushless motor sizes are very confusing for those coming over from i.c. powered models so have included this information to give you a general approximation. Electric motors are much more flexible than i.c. engines, being able to utilise a broader range of props. It is possible to choose a motor that turns a same size prop at the same revs as an i.c. engine, but you will get a much better performance if you utilise the flexibility of brushless motors correctly.
Accessories and Spares for your AirMax 4250 Motor
Please Note: The motor comes with all the parts listed in the Accessory Pack below so there is no need to order
Brushless Motor Accessory Pack for Airtek AirMax 4250 Series Motors
5.00 mm Alloy Collet Type Prop Shaft Adaptor HMPA09
Shaft for Airtek AirMax Series 4250 Motors
Spare shaft fits all Airtek AirMax 4250 series brushless outrunners.
ZTW Beatles Series 80A ESC
| The specifications above are supplied in good faith. As with all electric systems there are multiple combinations of Motor/ESC/Props and Batteries available, the change and variation of any of these (even the same size/specification from different manufacturers) will have an effect on the parameters/performance you can expect. We STRONGLY recommend the use of a wattmeter. These relatively inexpensive devices will not only bring some science into your hobby, allowing you to optimise your set up for better performance and duration, but will check if you are running within the limits of your equipment. Your first fried motor or burnt ESC will pay for a wattmeter! If you don’t use a wattmeter always check the temperature of your Motor/ESC after a run. Warm is OK - hot is NOT!